How to maintain your own front and rear wheel bearings

Front / rear bearing at least two years of maintenance time! (After the driver / front drive)
1, ready to lithium-based grease No. 2 or molybdenum disulfide grease, kerosene lamps or diesel 500 ml, waste cloth or old clothes, a washbasin, parts storage boxes, repair tools, markers.
2, choose a nice day without wind, to find a shady ground handbrake tension and hanging files hold car in rear / front tire hit the cover auxiliary fixed.
3, the first side front / rear wheel fixing bolts diagonally in order to loosen.
4, the side with a jack raise front / rear wheel stand or wooden tiles with a triangle pad steady, repeat the process pad steady the other side.
5, will have to loosen the front / rear mounting bolts Remove the storage parts box.
6 Remove the front / rear wheels.
7 Remove the front / rear brake brake pads (marked with a marker to distinguish between right and left outside).
8 Remove the front / rear bearing head cover cap.
9 Remove the bolt safety pin baskets.
10, loosen and remove the bolts.
11, remove the inner and outer bearing checking, as has been badly worn should be replaced!
12, if there is no serious wear and tear can be kerosene or diesel wash and wipe clean.
13, the inner and outer bearing grease evenly loaded back into place after.
14, and then tighten the bolt baskets rewind a half.
15, rotating front / rear taper roller bearing checking whether Songkuang or pull strength, adjusted to not repeat Songkuang not pull fresh state.
16, mounting bolts baskets insurance sales, front / rear axle cover cap.
17, carefully wipe the disc with a clean cloth, the surface oil,
18, check the brakes, and the surface of the sheet body, if damage should be trimmed or replaced.
19, install the front wheel, tighten the bolts in diagonal sequence.
20, the process is repeated to complete the other side of the care.
21, the side of the front wheels raised off with a jack stand or pad brick triangle, jack unload the front / rear wheels touch the ground. Repeat this process for the other side of the front / rear wheels touch the ground.
22, with a wrench by diagonal sequence tighten bolts tires (not less than 40 kg torque). Description; One person performs maintenance for about 2-3 hours.